Drizoro Maxrest Repair Mortar

No Primers Needed,

Just Wet The Surface

Product Description

MAXREST is a one-component structural repair mortar, made of special cements, additives and selected aggregates, which provides a thixotropic product with quick-setting time that does not shrink. It firmly adheres to the surface which it is applied on, restores concrete to its original condition.

Product & Uses Application Fields

• For general repair and restoration work on structural concrete. Repairs honeycombs, cracks and fissures. • Patching and protective covering of  reinforcing rods affect ed b y corrosion. • To repair lintels, ran, water tanks and to restore architectural concrete permanently exposed to climatic conditions. • Sealing of construction joints prior to waterproofing works in tanks, swimming pools, basements, etc. • For restoration of lines and shapes of damaged pre-fabricated concrete elements.

Product Benefits & Advantages

• Its quick-setting time, from 15 to 20 minutes, allows for a fast repair process. • It forms part of the substrate and repairs are structurally sound, with properties comparable or higher than concrete. • DOES NOT slump or needs form work. • It does not shrink or cracks when setting. • Odour-free and non-toxic, making it the ideal material to use in badly ventilated places, such as water tanks, shafts, sewers, etc. • Does not contain any chloride. • Only needs the addition of water for mixing

• Do not use leftover mixed material to prepare a new batch.
• Do not add sand, aggregates or cement to increase volume.
• Do not use high speed mixers
• Do not mix for prolonged periods.

• Do not apply on painted or structurally weak surfaces.
• Do not apply in layers exceeding 3 cm thickness.
• Do not allow the layers to heat up; Mist spray with water if required.
• Setting time is measured at 20 ºC. Higher temperatures reduce the setting time and lower temperatures delay the setting time.
• With low temperatures keep the product in a warm place and use lukewarm water to accelerate the setting time.
• With hot temperatures keep the product in a cool place and use fresh clean water for the mix. Wet the different layers. Mix small batches of material and apply immediately